Cablu RCA Van den Hul The First Ultimate MKII

Specificatii:

Capacitate:         61 pF/m

Culoare:               Light Yellow

Material:              Carbon

Tip cablu:             Interconect

Alte caracteristici:            product category             interconnect - Unbalanced, Analogue, Digital, Mid-range

cable type: Coaxial

conductor material: Linear Structured Carbon ®

design purpose: Highest quality line level audio interlink / SPDIF digital audio interconnect (75 Ohm) (*)

eff conductor    - / - / Core: 12,000; Screen: 114,000

external diameter           7.8 mm.

resistance Core: ~36 Ohm/m.; Screen: ~4.8 Ohm/m.

insulation Core: PE foam; Jacket: HULLIFLEX ® / 300 Vrms min.

connector types: Our RCA type C - 8.0.

With The FIRST ® Ultimate the sonic results are so different and also so much better than found with any metal product we know of, that we think this is a complete breakthrough in cable technology.

Besides the many highly innovative technical aspects of this product, its sonic aspects are even more attractive:

Especially the lack of dynamic compression on higher signal levels, the extended low level information and the total lack of any harshness make this cable so different from any other product known so far.

And for critical listeners with high demands on spatial reproduction, this is your final choice; no other product so far produced, renders so much spatial information as The FIRST ® Ultimate.

- The coaxial constructed The FIRST ® Ultimate has a LSC centre conductor with 12,000 individually insulated 7 micron strands with a total diameter of 1 mm. The individual strand insulation prevents electrons to cross from fibre to fibre. The direct result is that electrons exclusively move trough the 7 micron strands in one dimension. Side movements are virtually impossible. This prevents a lot of audio problems.

- In difference to our The FIRST ®, The FIRST ® Ultimate’s outer braiding, functioning as screen and signal return, is made of 6 (instead of 2) layers of braided LSC fibres. Together 114,000 individually insulated fibres.

With our classic The FIRST ® connecting to some brands of tube amplifiers in very rare occasions a slight background hum is audible. This weak hum is caused by excessive ground currents flowing through the (unbalanced) cable’s resistive shield, adding up to the audio signal. The FIRST ® Ultimate’s heavier shield exhibits a much reduced electrical series resistance, thus minimizing the risk of experiencing hum problems.

Due to the fact that most audio equipment in your installation is powered by the mains voltage, an unavoidable hum voltage residual is induced on all cabinets and audio grounds. At all audio devices these residual voltages are of different magnitude (or phase) and will balance out by means of ground currents flowing through the shields of your interconnecting cables. Generally, these ground currents are in the same order of magnitude as the audio signal currents being transferred (microAmperes); When using unbalanced interconnects they are likely to interfere, thereby reducing transparency and imaging.

With the Van Den Hul POLARITY CHECKER , you can simply fine-tune your audio system to eliminate, or at least strongly reduce, these residual ground currents and thus improve your system’s performance.

In persistent hum situations one can bypass the shield of The FIRST ® or even The FIRST ® Ultimate with a metal wire, or switch to our Linear Structured Carbon ® cables: The FIRST ® Metal Screen or The SECOND ® which have a metal shield of their own.